Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2007SUBURBAN C1500, 5.3 0REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1833 (KEYLESS ENTRY SYSTEM AND REMOTE FUNCTIONS)DIAGNOSTIC INFORMATION AND PROCEDURESKEYLESS ENTRY SYSTEM INOPERATIVECIRCUIT/SYSTEM TESTING
2007 Chevrolet Suburban C1500, 5.3 0
Circuit/System Testing
2007 Chevrolet Suburban C1500, 5.3 0SECTION Circuit/System Testing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Verify that the transmitter is the correct transmitter for the vehicle.
- If not the correct transmitter, replace the transmitter.
- Verify the scan tool FOB Programmed parameter for the appropriate transmitter is Yes.
- If not the specified value, program the transmitter. Refer to Remote Control Door Lock Transmitter Programming .
- Place the transmitter on the test pad of the J 43241 and press each transmitter button one at a time, holding each button for three seconds. The tester should sound a tone and illuminate a green light for the entire three second button press.
- If one or more buttons does not sound the tone and illuminate the green light for the entire three seconds, replace the transmitter battery and retest with the J 43241 . If the condition continues after battery replacement, replace the transmitter.
- Operate the transmitter while observing the scan tool Fob Function parameter for the appropriate transmitter. The parameter should correspond with the function selected on the transmitter.
- If the parameter does not match the function selected on the transmitter, replace the transmitter.
- Attempt to program the transmitter, refer to Remote Control Door Lock Transmitter Programming . The transmitter should program.
- If the transmitter does not program, test the keyless entry coax and/or antenna for a short to ground or an open/high resistance. If the circuit tests normal, replace the RCDLR.
- If all circuits test normal, replace the RCDLR.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.