Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2007SUBURBAN C1500, 5.3 0REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1233 (STEERING WHEEL & STEERING COLUMN)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2007 Chevrolet Suburban C1500, 5.3 0
Fastener Tightening Specifications
2007 Chevrolet Suburban C1500, 5.3 0SECTION Fastener Tightening Specifications
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Automatic Transmission Control Bolt | 10 N.m | 89 lb in |
| Shift Lever Bolt | 20 N.m | 15 lb ft |
| Steering Column Bracket Screw | 6 N.m | 53 lb in |
| Steering Column Bolt | 27 N.m | 20 lb ft |
| Steering Column Nut | 27 N.m | 20 lb ft |
| Steering Column Seal Nut | 3 N.m | 27 lb in |
| Steering Column Shroud Bolt | 3 N.m | 27 lb in |
| Steering Shaft Coupling Bolt (at the Upper Intermediate Shaft) | 50 N.m | 37 lb ft |
| Steering Shaft Coupling Bolt (at the Steering Gear) | 47 N.m | 35 lb ft |
| Steering Shaft Coupling Nut (at the Steering Column) | 62 N.m | 46 lb ft |
| Steering Wheel Heat Module Screw | 2 N.m | 18 lb in |
| Steering Wheel Nut | 41 N.m | 30 lb ft |
| Turn Signal Multifunction Switch Bolt | 3 N.m | 27 lb in |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.