Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Powertrain Control Module: Removal
2007 Chevrolet Suburban C1500, 5.3 0SECTION Removal
WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Ensure ignition is off. Disconnect negative battery cable. Locate PCM at left front corner of engine compartment. See Fig 1. Remove harness ground from the clip attached to the PCM cover (if equipped). If equipped with the Allison transmission, remove the engine harness clip from the PCM cover.
- Release PCM cover from mounting tabs on PCM bracket. Remove PCM cover from PCM. Loosen PCM harness connector bolts. See Fig 2. Disconnect PCM harness connectors. Release the PCM spring latch. Remove PCM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.