Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Drive Sprocket Support Assemble
2007 Chevrolet Monte Carlo V8-5.3LSECTION Drive Sprocket Support Assemble
Drive Sprocket Support Assemble
Tools Required
* J 8092 Driver Handle
* J 28677 Drive Sprocket Support Bearing Installer
* J 36850 Transmission Assembly Lubricant
1. Assemble J 28677 and J 8092.
2. Lubricate drive sprocket support bearing (521) with J 36850.
Important: When installing the new bearing the part number should be visible (facing upward).
3. Using the assembled tool, press in the drive sprocket support bearing (521).
4. Install the drive sprocket support assembly (522).
Notice: Refer to Fastener Notice.
5. Install the four drive sprocket support bolts (524).
Tighten the bolts to 25 N.m (18 lb ft).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.