Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006UPLANDER FWD V6-3.5L VIN LREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - BODY AND FRAMEPOWER SLIDING DOOR MODULESERVICE AND REPAIRACTUATOR CONTROL MODULE REPLACEMENT - PSD (WITH RPO CODE E59 LH)
2006 Chevrolet Uplander FWD V6-3.5L VIN L
Actuator Control Module Replacement - PSD (With RPO Code E59 LH)
2006 Chevrolet Uplander FWD V6-3.5L VIN LSECTION Actuator Control Module Replacement - PSD (With RPO Code E59 LH)
ACTUATOR CONTROL MODULE REPLACEMENT - PSD (WITH RPO CODE E59 LH)
REMOVAL PROCEDURE
1. Remove the left rear quarter lower trim panel.
2. Disconnect the electrical connectors (1) from the power sliding door (PSD) actuator control module (3).
3. Release the integral clips (2) securing the actuator module to the top side of the motor module bracket (4).
4. Pull the PSD actuator control module (3) inboard in order to release the control module from the actuator motor module bracket.
INSTALLATION PROCEDURE
1. Push the PSD actuator control module (3) outboard in order to hook the control module to the actuator motor bracket (4).
2. Connect the PSD actuator control module electrical connectors (1).
3. Perform the re-initialization procedure. Refer to Actuator Control Module - Power Sliding Door (PSD) Programming and Setup.
4. Install the left rear quarter lower trim panel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.