Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006TAHOE 2WD V8-4.8L VIN VREPAIR AND DIAGNOSISBODY AND FRAMESEATSSERVICE AND REPAIRREMOVAL AND REPLACEMENTSEAT ADJUSTER REPLACEMENT - FRONT (MANUAL)
2006 Chevrolet Tahoe 2WD V8-4.8L VIN V
Seat Adjuster Replacement - Front (Manual)
2006 Chevrolet Tahoe 2WD V8-4.8L VIN VSECTION Seat Adjuster Replacement - Front (Manual)
Seat Adjuster Replacement - Front (Manual)
Removal Procedure
1. Remove the front seat from the vehicle.
2. Remove the seat trim panel.
3. Remove the seat cushion frame.
4. Remove the seat back frame.
5. Remove the seat back hinge/recliner mechanism.
6. Remove the seat adjuster track cover.
7. Remove the inboard seat belt buckle and nut (1).
Disconnect the electrical connection (2).
8. Remove the bar (1) from the adjuster tracks (2). Straighten the tabs in order to remove the bar.
9. Remove the cross brace (3).
10. Remove the EZ entry rod (4), if equipped with the EZ entry feature.
11. Remove the cushion tilt mechanism, if equipped.
Installation Procedure
1. Install the cushion tilt mechanism, if equipped.
2. Install the EZ entry rod (4), if equipped with the EZ entry feature.
3. Install the cross brace (3).
4. Install the bar (1) onto the racks (2). Bend the tabs in order to secure the bar.
Notice: Refer to Fastener Notice in Service Precautions.
5. Install the inboard seat belt buckle and nut (1).
Tighten the nut to 53 N.m (39 lb ft).
6. Connect the electrical connection (2).
7. Install the seat adjuster track cover.
8. Install the seat back hinge/recliner mechanism.
9. Install the seat back frame.
10. Install the seat cushion frame.
11. Install the seat trim panel.
12. Install the front seat in the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.