Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
2006 Chevrolet Suburban K2500, 6.0 USECTION Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Remove the intake air resonator. Refer to Intake Air Resonator Replacement .
- Disconnect the mass air flow/intake air temperature (MAF/IAT) sensor electrical connector (3).
- Pull up on the air cleaner assembly (1) in order to release the retainers from the air cleaner adapter (2).
- If necessary, loosen the MAF/IAT sensor clamp.
- Remove the MAF/IAT sensor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.