Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 946 (POWER SEAT SYSTEM)REPAIR INSTRUCTIONSMEMORY SEAT CONTROL MODULE REPLACEMENT
2006 Chevrolet Suburban K2500, 6.0 U
Memory Seat Control Module Replacement
2006 Chevrolet Suburban K2500, 6.0 USECTION Memory Seat Control Module Replacement
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Memory Seat Control Module Replacement
| Callout | Component Name |
|---|---|
| Preliminary Procedure: Remove the front driver seat. Refer to Front Seat Replacement - Bucket . |
|
| 1 | Driver Seat Adjuster Outer Finish Cover Refer to Seat Cushion Outer Trim Panel Replacement - Front Seat (Manual) or Seat Cushion Outer Trim Panel Replacement - Front Seat (Power) . |
| 2 | Driver Seat Adjuster Inner Finish Cover Refer to Seat Cushion Inner Trim Panel Replacement - Front . |
| 3 | Driver Seat Riser Finish Cover Tip: Pull rearward to disengage the cover from the seat riser. |
| 4 | Driver Seat Cushion Cover and Pad Refer to Seat Cushion Trim Cover and Pad Replacement . |
| 5 | Memory Seat Module Nut (Qty: 4)
NOTE:
Refer to Fastener Notice
.
Tighten: 9 N.m (80 lb in) |
| 6 | Memory Seat Module Tip: Disconnect the electrical connector. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.