Installation Procedure

2006 Chevrolet Suburban K2500, 6.0 USECTION Installation Procedure
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Rear Glass Run Channel
    GM940703Courtesy of GENERAL MOTORS CORP.
  1. Install the rear glass run channel with rivets.
  2. Fig 2: View Of Front Door Window Channel Retainer
    GM940638Courtesy of GENERAL MOTORS CORP.
  3. Position the front glass run channel retainer.
  4. NOTE: Refer to Fastener Notice .
  5. Install the retainer bolts.

    Tighten:Β  Tighten the bolts to 10 N.m (89 lb in).

  6. Install the portion of the water deflector that was loosened to gain access to the bolts.
  7. Install the front door trim panel. Refer to Front Side Door Trim Panel Replacement .
  8. Install the front door window run channel. Refer to Front Side Door Window Channel ReplacementΒ .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.