Scan Tool Data List

2006 Chevrolet Suburban K2500, 6.0 USECTION Scan Tool Data List
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
Communication Interface Module

Scan Tool Parameter Data List Units Displayed Typical Data Value
Operating Conditions: Ignition ON with Engine OFF
8-Digit GM Part Number Module 2 8 Digits 15258785
Component Serial Number 13-16 Module 1 4 Digits Varies
Date Data Date DD/MM/YYYY
Electronic Serial Number Module 2 11 Digits 03600326309
GPS Signal GPS Data Yes/No Yes
Julian Date of Build Module 1 3 Digits Varies
Module ID Module 2 Alpha-numeric Generation 7
Signal Strength Signal Strength 0-100 68
Signal Type Signal Strength Analog/Digital Digital
Software ID Module 1 3 Digits Varies
Time GPS Data Time HH:MM:SS
Transceiver ID Signal Strength 2-5 Digits Varies
VCI Module Station ID Module 2 Numeric 020000141
Year Module Built Module 1 4 Digits 2005
Digital Radio Receiver

Scan Tool Parameter Data List Units Displayed Typical Data Value
Operating Conditions: Ignition ON/Engine OFF/Radio ON
Battery Voltage Data Volts Varies
Ignition Counter Data Numeric Varies
Power Mode Data Alphanumeric Run
Radio

Scan Tool Parameter Data List Units Displayed Typical Data Value
Operating Conditions: Ignition ON with Engine OFF
8-Digit GM Part Number Module 2 8 Digits 93807890
Component Serial Number 13-16 Module 1 4 Digits 0007
Date GPS Data Date DD/MM/YY
Electronic Serial Number Module 2 11 Digits 16832516749
GPS Signal GPS Data Yes/No Yes
Julian Date of Build Module 1 3 Digits 067
Module ID Module 2 Alpha-numeric Generation 6
Signal Strength Signal Strength 0-100 68
Signal Type Signal Strength Analog/Digital Digital
Software ID Module 1 3 Digits 146
Time GPS Data Time HH:MM:SS
Transceiver ID Signal Strength 2-5 Digits Varies
VCI Module Station ID Module 2 10 Digits 0002086783
Year Module Built Module 1 4 Digits 2001
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.