Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 727 (POWER STEERING SYSTEM)REPAIR INSTRUCTIONSPOWER STEERING PULLEY REPLACEMENTINSTALLATION PROCEDURE
2006 Chevrolet Suburban K2500, 6.0 U
Installation Procedure
2006 Chevrolet Suburban K2500, 6.0 USECTION Installation Procedure
WARNING: This page is about a different car, the 2006 GMC Sierra, 2006 GMC Cab & Chassis Sierra, 2006 Chevrolet Silverado, and 2006 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Place the power steering pump pulley on the end of the power steering pump shaft.
- Install the power steering pump pulley using J 25033-C . See Special Tools .
- Ensure that the power steering pump pulley (1) is flush against the power steering pump shaft (2), with an allowable variance of 0.25 mm (0.010 in).
- Install the drive belt. Refer to one of the following:
- Drive Belt Replacement in Engine Mechanical - 4.3L.
- Drive Belt Replacement - Accessory (4.8L, 5.3L, and 6.0L Engines) or Drive Belt Replacement - Accessory (5.3L Engine w/RPO HP2) in Engine Mechanical - 4.8L, 5.3L, and 6.0L.
- Drive Belt Replacement in Engine Mechanical - 6.6L (LLY).
- Drive Belt Replacement - Accessory in Engine Mechanical - 8.1L.
- Install the upper fan shroud. Refer to Fan Shroud Replacement - Upper (w/RPO HP2) , Fan Shroud Replacement - Upper (Automatic Transmission - Diesel) , Fan Shroud Replacement - Upper (Manual Transmission - Diesel) , Fan Shroud Replacement - Upper (Automatic Transmission - Gasoline) or Fan Shroud Replacement - Upper (Manual Transmission - Gasoline) in Engine Cooling.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.