Installation Procedure

2006 Chevrolet Suburban K2500, 6.0 USECTION Installation Procedure
WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the DVD player hook (1) into the hook opening.
    Fig 1: Installing DVD Player Hook Into Hook Opening
    G01578875Courtesy of GENERAL MOTORS CORP.
  2. Connect the wire connector (1) to the DVD player assembly.
    IMPORTANT: Ensure the harness is routed to the right side of the large plastic pin as shown (2).
  3. Install the harness retainer to the panel.
  4. Swing the rear part of the assembly to the headliner so that the retainer is seated.
    Fig 2: Connecting Wire Connector To DVD Player Assembly
    G01578876Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.