Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 527 (SEAT SYSTEM)REPAIR INSTRUCTIONSSEAT BACK RELEASE CABLE REPLACEMENT - FRONTINSTALLATION PROCEDURE

2006 Chevrolet Suburban K2500, 6.0 U

Installation Procedure

2006 Chevrolet Suburban K2500, 6.0 USECTION Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Insert the release cables through the opening in the upper seat back frame.
Snap the release lever mechanism to the seat back frame.
Route the cables.

Fig 1: Inserting Release Cables Through Opening In Upper Seat Back Frame
Courtesy of GENERAL MOTORS CORP.
Install the release cables to the right and left hinges inserting the locking pins in the notches.
Apply Loctite™ 271 to the hinge bolts.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
Install the nuts to the right and left hinge bolts.
Tighten

Tighten the hinge bolt nuts to 24 N.m (18 lb ft).
Install the seat back free play retention cable (passenger seat only).

Fig 2: Installing Release Cables To Right & Left Hinges
Courtesy of GENERAL MOTORS CORP.
Install the seat back trim cover. Refer to SEAT BACK COVER AND PAD REPLACEMENT - FRONT (RPO AR9 BASE SEAT) .
Install the release lever bezel.

Fig 3: Seat Back Trim Cover
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.