Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 512 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSHIGH MOUNTED STOP LAMP REPLACEMENTINSTALLATION PROCEDURE
2006 Chevrolet Suburban K2500, 6.0 U
Installation Procedure
2006 Chevrolet Suburban K2500, 6.0 USECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Install the high-mounted stop lamp into position inside the rear fascia.
- Loosely install the stop lamp mounting screws.NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
- Align the stop lamp to the rear fascia, then press and hold the lamp to the fascia for flushness.
Tighten
Tighten the high-mounted stop lamp retaining screws to 4 N.m (35 lb in).
- Connect the electrical connector to the stop lamp.
- Install the inner tail lamp. Refer to TAIL LAMP REPLACEMENT .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.