SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 382 (ENGINE CONTROLS - 4.3L (INTRODUCTION))REPAIR INSTRUCTIONSCAMSHAFT POSITION (CMP) SENSOR REPLACEMENTREMOVAL PROCEDURE
2006 Chevrolet Suburban K2500, 6.0 U

Removal Procedure

2006 Chevrolet Suburban K2500, 6.0 USECTION Removal Procedure
WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the ignition coil wire from the distributor.
    2. Fig 1: View Of Ignition Coil Wire At Distributor
    GM302854Courtesy of GENERAL MOTORS CORP.
  2. Remove the spark plug wires from the distributor.
    1. Twist the spark plug wire boot 1/2 turn.
    2. Pull only on the boot or use a tool designed for this purpose in order to remove the wires from the distributor.
  3. Disconnect the camshaft position (CMP) sensor electrical connector (2).
    4. Fig 2: View Of Ground Strap And CMP & Fuel Pump/Oil Pressure Sensor Connectors
    GM782680Courtesy of GENERAL MOTORS CORP.
  4. Remove the distributor cap screws.
    5. Fig 3: View Of Distributor Cap Screws
    GM157984Courtesy of GENERAL MOTORS CORP.
  5. Remove the distributor cap.
    6. Fig 4: View Of Distributor Cap
    GM157986Courtesy of GENERAL MOTORS CORP.
  6. Remove the rotor screws.
    7. Fig 5: View Of Rotor Screws
    GM4354Courtesy of GENERAL MOTORS CORP.
  7. Remove the rotor.
    8. Fig 6: View Of Rotor
    GM156748Courtesy of GENERAL MOTORS CORP.
  8. Align the square slot in the reluctor wheel with the CMP sensor.
    9. Fig 7: View Of Square-Cut Hole In Vane Wheel
    GM156754Courtesy of GENERAL MOTORS CORP.
  9. Remove the CMP screws.
    10. Fig 8: View Of CMP Screws
    GM4341Courtesy of GENERAL MOTORS CORP.
  10. Remove the CMP sensor.
    11. Fig 9: View Of CMP Sensor & Screws
    GM301398Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.