SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 331 (STATIONARY WINDOW SYSTEM)REPAIR INSTRUCTIONSWINDSHIELD SIDE REVEAL MOLDING REPLACEMENTINSTALLATION PROCEDURE
2006 Chevrolet Suburban K2500, 6.0 U

Installation Procedure

2006 Chevrolet Suburban K2500, 6.0 USECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the windshield reveal molding to the windshield pillar.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the screws to the windshield reveal molding.

    Tighten 

    1. Tighten the screws to the windshield reveal molding to 2 N-m (18 lb in).
    Fig 1: Installing Screws To Windshield Reveal Molding
    G01458516Courtesy of GENERAL MOTORS CORP.
  3. Install the front door sealing weatherstrip (1) to the pinch-weld.
  4. Close the door.
    Fig 2: Installing Front Door Sealing Weatherstrip To Pinch-Weld
    G01458517Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.