Rear Door Speaker Removal/Installation: Notes

2006 Chevrolet Suburban K2500, 6.0 USECTION Notes
WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the sail garnish. (5 door) (See SAIL GARNISH REMOVAL/INSTALLATION .)
  3. Remove the regulator handle. (Vehicle without power window system) (See REGULATOR HANDLE REMOVAL .) (See REGULATOR HANDLE INSTALLATION .)
  4. Remove the rear door trim. (See REAR DOOR TRIM REMOVAL/INSTALLATION .)
  5. Remove in the order indicated in the table.
    REMOVAL ORDER OF REAR DOOR SPEAKER

    1 Screw
    2 Connector
    3 Rear door speaker (See Rear Door Speaker Installation NoteΒ .)
  6. Install in the reverse order of removal.
    Fig 1: Removing/Installing Rear Door Speaker
    G02566640Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.