Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 265 (ON-BOARD DIAGNOSTIC [ENGINE CONTROL SYSTEM])OBD-II DRIVE MODEPCM ADAPTIVE MEMORY PRODUCTION DRIVE MODE
2006 Chevrolet Suburban K2500, 6.0 U
PCM Adaptive Memory Production Drive Mode
2006 Chevrolet Suburban K2500, 6.0 USECTION PCM Adaptive Memory Production Drive Mode
WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
- Start the engine and warm it up completely.
- Verify the following conditions and correct if necessary:
- All accessory loads (A/C, headlights, blower fan, rear window defroster) are off.
- Initial ignition timing and idle speed are within the specification.
- Perform no load racing at the engine speed shown in the graph, then idle the engine for more than 20 s after the cooling fan has stopped. If possible, monitor RPM PID for engine speed during this procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.