Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 242 (ENTERTAINMENT SYSTEM)REPAIR INSTRUCTIONSSPEAKER REPLACEMENT - REARINSTALLATION PROCEDURE

2006 Chevrolet Suburban K2500, 6.0 U

Installation Procedure

2006 Chevrolet Suburban K2500, 6.0 USECTION Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Install the rear header speaker to the rear header speaker housing.
CAUTION: Refer to FASTENER NOTICE .
Install the screws in order to retain the rear header speaker to the rear header speaker housing.
Tighten

Tighten the screws in order to retain the rear header speaker to the speaker housing to 2 N.m (18 lb ft).
Connect the electrical connector to the speaker.
Install the rear header speaker housing to the vehicle.

Fig 1: Installing Rear Header Speaker
Courtesy of GENERAL MOTORS CORP.
Install the nuts in order to retain the rear header speaker housing to the vehicle.
Tighten

Tighten the nuts in order to retain the rear header speaker housing to the vehicle to 6 N.m (53 lb in).
Install the rear header trim panel, if equipped.

Fig 2: Installing Rear Header Trim Panel
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.