Installation Procedure

2006 Chevrolet Suburban K2500, 6.0 USECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the bulb (4) to the socket.
  2. Push in on the bulb (4) and turn 1/4 turn clockwise.
  3. Install the bulb (4) and socket into the rubber grommet in the headlamp capsule (1).
  4. Install the headlamp capsule (1) to the headlamp housing.
  5. Install the retaining ring to the headlamp housing assembly.
    CAUTION: Refer to FASTENER NOTICE .
  6. Install the screws to the retaining ring to the headlamp housing assembly.

    TightenΒ 

    Tighten the screws to 1.5 N.m (13 lb in).

    Fig 1: Installing Position Lamp
    G02422322Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.