SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2170 (COMPONENT CONNECTOR END VIEW (1 OF 5))AUTOMATIC LEVEL CONTROL (ALC) COMPRESSOR (Z55)
2006 Chevrolet Suburban K2500, 6.0 U

Automatic Level Control (ALC) Compressor (Z55)

2006 Chevrolet Suburban K2500, 6.0 USECTION Automatic Level Control (ALC) Compressor (Z55)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Automatic Level Control (ALC) Compressor (Z55) Connector End View
GM646372Courtesy of GENERAL MOTORS CORP.
Automatic Level Control (ALC) Compressor (Z55)

Pin Wire Color Circuit Function
A 0.5 TN 6075 Automatic Level Control Pressure Sensor Signal
B 2 RD/WH 2440 Battery Positive Voltage
C 0.5 WH 320 Automatic Level Control Exhaust Solenoid Control
D - - Not Used
E 3 L-BU 2248 Automatic Level Control Air Compressor Control
F 0.5 BN 6077 Low Reference
G 3 BK 1750 Ground
H 0.5 GY 6076 5-Volt Reference
Connector Part Information 
  • OEM: 15326654
  • Service: 88986254
  • Description: 8-Way F Metri-Pack 280 Series, Sealed (BK)
Terminal Part Information 
  • Terminal/Tray: See Terminal Repair Kit
  • Core/Insulation Crimp: See Terminal Repair Kit
  • Release Tool/Test Probe: See Terminal Repair Kit
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.