SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2143 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - ELECTRONIC COMPASS MODULE TO MEMORY SEAT MODULE (X4))COMPONENT CONNECTOR END VIEWSHEATED SEAT ELEMENT - PASSENGER BACK (HP2, KA1 OR KB6)
2006 Chevrolet Suburban K2500, 6.0 U

Heated Seat Element - Passenger Back (HP2, KA1 or KB6)

2006 Chevrolet Suburban K2500, 6.0 USECTION Heated Seat Element - Passenger Back (HP2, KA1 or KB6)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
GM283890Courtesy of
Connector Part Information
  • Harness Type: Passenger Seat
  • OEM Connector: 12066498 (HP2)
  • OEM Connector: 15419810 (Except HP2)
  • Service Connector: 12085536
  • Description: 4-Way M Metri-Pack 150 Series (BK)
Terminal Part Information
  • Pins: A, B
  • Terminated Lead: 13505668
  • Release Tool: J-38125-12A
  • Diagnostic Test Probe: J-35616-3 (GY)
  • Terminal/Tray: 12047581/2
  • Core/Insulation Crimp: E/C
  • Pins: C, D
  • Terminated Lead: 13575462
  • Release Tool: J-38125-12A
  • Diagnostic Test Probe: J-35616-3 (GY)
  • Terminal/Tray: 12047581/2
  • Core/Insulation Crimp: E/A
Heated Seat Element - Passenger Back (HP2, KA1 or KB6)

Pin Wire Circuit Function
A 1 D-BU 2479 Heated Seat Cushion Element Control
B 1 L-BU 2433 Ground
C 0.35 TN 2436 Passenger Heated Seat Back Temperature Sensor Signal
D 0.35 TN/BK 2482 Low Reference
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.