SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2076 (DISC BRAKE SYSTEM)REPAIR INSTRUCTIONSFRONT BRAKE CALIPER HARDWARE REPLACEMENT (2500 SERIES)REMOVAL PROCEDURE
2006 Chevrolet Suburban K2500, 6.0 U

Removal Procedure

2006 Chevrolet Suburban K2500, 6.0 USECTION Removal Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the fluid level in the brake master cylinder reservoir.
  2. If the brake fluid level is midway between the maximum-full point and the minimum allowable level, no brake fluid needs to be removed from the reservoir before proceeding.
  3. If the brake fluid level is higher than midway between the maximum-full point and the minimum allowable level, remove brake fluid to the midway point before proceeding.
  4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  5. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
    6. Fig 1: Compressing Brake Caliper Pistons
    GM370154Courtesy of GENERAL MOTORS COMPANY
  6. Compress the brake caliper pistons.
    1. Install 2 large C-clamps over the top of the caliper housing and against the back of the outboard brake pad.
    2. Slowly tighten the C-clamps until the caliper pistons are pushed completely into the caliper bores.
    3. Remove the C-clamps from the caliper.
    7. Fig 2: View Of Brake Caliper Mounting
    GM789166Courtesy of GENERAL MOTORS COMPANY
  7. Remove the brake caliper guide pin bolts.
    8. WARNING:

    Do not depress the brake pedal with the brake rotors/calipers and/or the brake drums removed. Damage to the brake system may result. If brake system damage occurs and is not repaired, vehicle damage and/or personal injury or death may result.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.