SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2052 (POWER DOOR LOCK SYSTEM AND RELEASE SYSTEMS)REPAIR INSTRUCTIONSLIFTGATE CLOSE ACTUATOR MOTOR CONTROL MODULE REPLACEMENT (EXCEPT AVALANCHE AND ESCALADE EXT)
2006 Chevrolet Suburban K2500, 6.0 U

Liftgate Close Actuator Motor Control Module Replacement (Except Avalanche and Escalade EXT)

2006 Chevrolet Suburban K2500, 6.0 USECTION Liftgate Close Actuator Motor Control Module Replacement (Except Avalanche and Escalade EXT)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Liftgate Actuator Drive Unit Bolts
GM1735866Courtesy of GENERAL MOTORS COMPANY
Liftgate Close Actuator Motor Control Module Replacement (Except Avalanche and Escalade EXT)

Callout Component Name

Preliminary Procedures

  1. Remove the bodyside trim panel. Refer to Rear Quarter Trim Panel Replacement - Left Side (Standard Wheelbase w/E61) , Rear Quarter Trim Panel Replacement - Left Side (Extended Wheelbase w/E61) , Rear Quarter Trim Panel Replacement - Left Side (Extended Wheelbase w/o E61) , Rear Quarter Trim Panel Replacement - Left Side (Standard Wheelbase w/o E61) .
  2. Disconnect the power liftgate actuator rod. Refer to Liftgate Actuator Rod Replacement (Except Avalanche and EXT Escalade) .
1 Liftgate Close Actuator Motor Control Module

Procedure

  • Disconnect the electrical connector.
  • Cut the tie strap, if equipped.
2 Liftgate Close Actuator Motor Control Module Bolt (Qty: 3)
CAUTION:

Refer to Fastener Caution .


Tighten 
9 N.m (80 lb in)
3 Liftgate Close Actuator Motor Control Module
Procedure 
If a replacement control module is installed, program the module. Refer to Control Module References .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.