SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2044 (CELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEM)REPAIR INSTRUCTIONSRADIO REPLACEMENT (EXCEPT CADILLAC)
2006 Chevrolet Suburban K2500, 6.0 U

Radio Replacement (Except Cadillac)

2006 Chevrolet Suburban K2500, 6.0 USECTION Radio Replacement (Except Cadillac)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Radio Assembly & Screws
GM1696487Courtesy of GENERAL MOTORS COMPANY
Radio Replacement (Except Cadillac)

Callout Component Name
NOTE:

Use a scan tool to retrieve the radio part number before removing the radio from the vehicle.

Preliminary Procedures

  1. Remove the accessory switch assembly. Refer to Accessory Switch Replacement (Cadillac) , Accessory Switch Replacement (Except Cadillac) .
  2. Remove the HVAC control module. Refer to HVAC Control Module Replacement , or HVAC Control Module Replacement .
1 Radio Screw (Qty: 4)
CAUTION:

Refer to Fastener Caution .


Tighten 
2 N.m (18 lb in)
2 Radio Assembly
  • Disconnect the electrical connector.
  • Disconnect the antenna cable.
  • Reprogram the radio after replacement. Refer to Control Module References .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.