SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2002 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - A/C COMPRESSOR THROUGH ELECTRONIC POWER STEERING MODULE X1)COMPONENT CONNECTOR END VIEWSDOOR LOCK/WINDOW SWITCH - PASSENGER X2
2006 Chevrolet Suburban K2500, 6.0 U

Door Lock/Window Switch - Passenger X2

2006 Chevrolet Suburban K2500, 6.0 USECTION Door Lock/Window Switch - Passenger X2
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Door Lock/Window Switch - Passenger X2 Connector End View
GM1962089Courtesy of GENERAL MOTORS CORP.
Door Lock/Window Switch - Passenger X2

Pin Wire Circuit Function
1 0.5 D-BU/WH 1315 Right Front Turn Signal Lamp Control
2 - - Not Used
3 0.35 TN 1047 LIN Bus (Z75)
4 - - Not Used
5 0.35 YE 5943 Low Reference
6 - - Not Used
7 0.5 TN 5946 Passenger Door Lock Actuator Lock Control
8 0.5 GY/BK 1663 Passenger Door Lock Actuator Unlock Control
9 0.35 D-GN 5060 Low Speed GMLAN Serial Data
10 0.35 L-BU 661 Right Courtesy Lamp Control (Z75)
11-12 - - Not Used
13 0.35 TN/WH 746 Right Front Door Ajar Switch Signal
14 - - Not Used
15 0.35 BK 1050 Ground (Z75)
16 - - Not Used
Connector Part Information
  • Harness Type: Passenger Door
  • OEM Connector: 15486794
  • Service Connector: 19178169
  • Description: 16-Way F Micro HVT Series (BN)
Terminal Part Information
  • Terminated Lead: 13575550
  • Release Tool: J-38125-559
  • Diagnostic Test Probe: J-35616-16 (L-GN)
  • Terminal/Tray: 15445905/23
  • Core/Insulation Crimp: J/J
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.