SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2002 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - A/C COMPRESSOR THROUGH ELECTRONIC POWER STEERING MODULE X1)COMPONENT CONNECTOR END VIEWSBRAKE MASTER CYLINDER PISTON POSITION SENSOR (HP2)
2006 Chevrolet Suburban K2500, 6.0 U

Brake Master Cylinder Piston Position Sensor (HP2)

2006 Chevrolet Suburban K2500, 6.0 USECTION Brake Master Cylinder Piston Position Sensor (HP2)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Brake Master Cylinder Piston Position Sensor (HP2) Connector End View
GM2001259Courtesy of GENERAL MOTORS CORP.
Brake Master Cylinder Piston Position Sensor (HP2)

Pin Wire Circuit Function
1 0.5 RD/BK 912 Pedal Travel Sensor Signal B
2 0.5 RD/BK 910 5-Volt Reference
3 0.5 RD/BK 911 Pedal Travel Sensor Signal A
4 0.5 OG/BK 6045 Low Reference
5 - - Not Available
Connector Part Information
  • Harness Type: Instrument Panel
  • OEM Connector: 13509357
  • Service Connector: 19180277
  • Description: 5-Way F 64 Series, Sealed (BK)
Terminal Part Information
  • Terminated Lead: 13575867
  • Release Tool: J-38125-215A
  • Diagnostic Test Probe: J-35616-64B (L-BU)
  • Terminal/Tray: SAIT-A03T-M064/14
  • Core/Insulation Crimp: P/P
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.