SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2002 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - A/C COMPRESSOR THROUGH ELECTRONIC POWER STEERING MODULE X1)COMPONENT CONNECTOR END VIEWSAIR TEMPERATURE ACTUATOR - LEFT
2006 Chevrolet Suburban K2500, 6.0 U

Air Temperature Actuator - Left

2006 Chevrolet Suburban K2500, 6.0 USECTION Air Temperature Actuator - Left
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Air Temperature Actuator - Left Connector End View
GM280764Courtesy of GENERAL MOTORS CORP.
Air Temperature Actuator - Left

Pin Wire Circuit Function
5 0.35 BN 839 Ignition Voltage
6 0.35 D-BU 1199 Left Air Temperature Door Control
7 0.35 YE 1791 Low Reference
8 - - Not Used
9 0.35 L-BU 733 Left Air Temperature Door Position Signal
10 0.35 L-BU/BK 598 5-Volt Reference
Connector Part Information
  • Harness Type: HVAC
  • OEM Connector: 12064993
  • Service Connector: 12102485
  • Description: 6-Way F Micro-Pack 100 Series (BK)
Terminal Part Information
  • Terminated Lead: Service by Connector Assembly - 12102485
  • Release Tool: J-38125-13A
  • Diagnostic Test Probe: J-35616-6 (BN)
  • Terminal/Tray: Not Available
  • Core/Insulation Crimp: Not Available
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.