Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1913 (POWER DOOR LOCK SYSTEM AND RELEASE SYSTEMS)DIAGNOSTIC INFORMATION AND PROCEDURESDTC B153FCIRCUIT/SYSTEM TESTING
2006 Chevrolet Suburban K2500, 6.0 U
Circuit/System Testing
2006 Chevrolet Suburban K2500, 6.0 USECTION Circuit/System Testing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the B71R liftgate object sensor - right.
- Test for less than 10 Ξ© between the low reference circuit terminal B and ground.
- If greater than the specified range, test the low reference circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the K39 liftgate module.
- Disconnect the harness connector at the B71L liftgate object sensor - left.
- Ignition ON, test for 4.75-5.25 V between the signal circuit terminal A and ground.
- If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the K39 liftgate module.
- If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the K39 liftgate module.
- Test of infinite resistance between the signal circuit terminal B and ground.
- If not the specified value, test the signal circuit for a short to ground.
- Test for less than 10 Ξ© between the signal circuit terminal A at the B71R liftgate object sensor - right and the signal circuit terminal B at the B71L liftgate object sensor - left.
- If greater than the specified range, test the signal circuit for an open/high resistance.
- If all circuits test normal, test or replace the appropriate B71 liftgate object sensor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.