SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1912 (FIXED AND MOVEABLE WINDOWS)REPAIR INSTRUCTIONSFRONT SIDE DOOR WINDOW REGULATOR REPLACEMENT (POWER)
2006 Chevrolet Suburban K2500, 6.0 U

Front Side Door Window Regulator Replacement (Power)

2006 Chevrolet Suburban K2500, 6.0 USECTION Front Side Door Window Regulator Replacement (Power)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Front Side Power Door Window Regulator
GM1673129Courtesy of GENERAL MOTORS CORP.
Front Side Door Window Regulator Replacement (Power)

Callout Component Name

Preliminary Procedures

  1. Position the door window as needed for service.
  2. Remove the front door trim panel. Refer to Front Side Door Trim Panel Replacement .
  3. Remove the front door water deflector. Refer to Front Side Door Water Deflector Replacement .
1 Front Side Door Window Bolt (Qty: 2)
CAUTION:

Refer to Fastener Caution .

Procedure

  1. Tape the window to the door frame to prevent it from moving.
  2. Loosen the 2 bolts that attach the window to the window regulator.
  3. Disconnect the electrical connector.

Tighten 
9 N.m (80 lb in)
2 Front Side Door Window Regulator Bolt (Qty: 3)
Tighten 
9 N.m (80 lb in)
3 Front Side Door Window Regulator Nut (Qty: 2)
Tighten 
9 N.m (80 lb in)
4 Front Side Door Window Regulator
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.