SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1909 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - MODE ACTUATOR THROUGH YAW SENSOR)COMPONENT CONNECTOR END VIEWSTURN SIGNAL/MULTIFUNCTION SWITCH X1
2006 Chevrolet Suburban K2500, 6.0 U

Turn Signal/Multifunction Switch X1

2006 Chevrolet Suburban K2500, 6.0 USECTION Turn Signal/Multifunction Switch X1
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Turn Signal/Multifunction Switch X1 Connector End View
GM39746Courtesy of GENERAL MOTORS CORP.
Turn Signal/Multifunction Switch X1

Pin Wire Circuit Function
A-B - - Not Used
C 0.35 BK/WH 1851 Ground
D 0.35 TN 664 Hazard Switch Turn Right Signal
E 0.35 D-GN 663 Hazard Switch Left Turn Signal
F 0.35 BK/WH 1851 Ground
G 0.35 WH 111 Hazard Switch Signal
H - - Not Used
Connector Part Information
  • Harness Type: Steering Column
  • OEM Connector: 12064862
  • Service Connector: 12126438
  • Description: 8-Way F Metri-Pack 150 Series (L-GY)
Terminal Part Information
  • Terminated Lead: Service by Connector Assembly - 12126438
  • Release Tool: Pending
  • Diagnostic Test Probe: Pending
  • Terminal/Tray: Not Available
  • Core/Insulation Crimp: Not Available
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.