SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1909 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - MODE ACTUATOR THROUGH YAW SENSOR)COMPONENT CONNECTOR END VIEWSSEAT CLIMATE CONTROL MODULE X2 (KB6)
2006 Chevrolet Suburban K2500, 6.0 U

Seat Climate Control Module X2 (KB6)

2006 Chevrolet Suburban K2500, 6.0 USECTION Seat Climate Control Module X2 (KB6)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Seat Climate Control Module X2 (KB6) Connector End View
GM1455858Courtesy of GENERAL MOTORS CORP.
Seat Climate Control Module X2 (KB6)

Pin Wire Circuit Function
1 0.35 PK 239 Ignition Voltage
2 0.35 GY 2434 Passenger Seat Cushion Temperature Sensor Signal
3 0.35 PK 2435 Low Reference
4 0.35 TN 2436 Passenger Seat Back Temperature Sensor Signal
5 0.35 TN 2482 Low Reference
6 - - Not Used
7 0.35 YE/BK 2079 Driver Seat Cushion Temperature Sensor Signal
8 0.35 YE 2080 Low Reference
9 0.35 D-BU 2425 Driver Seat Back Temperature Sensor Signal
10 0.35 PK 2426 Low Reference
Connector Part Information
  • Harness Type: Passenger Seat
  • OEM Connector: 15431080
  • Service Connector: 88988292
  • Description: 10-Way F Micro-Pack 64 Series (BK)
Terminal Part Information
  • Terminated Lead: 13575845
  • Release Tool: J-38125-215A
  • Diagnostic Test Probe: J-35616-64B (L-BU)
  • Terminal/Tray: Not Available
  • Core/Insulation Crimp: P/P
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.