SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1908 (BATTERY, CHARGING SYSTEM AND STARTING SYSTEM)REPAIR INSTRUCTIONSGENERATOR BATTERY JUMPER CABLE REPLACEMENTREMOVAL PROCEDURE
2006 Chevrolet Suburban K2500, 6.0 U

Removal Procedure

2006 Chevrolet Suburban K2500, 6.0 USECTION Removal Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Mega Fuse Cover
    GM1702800Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
  3. Remove the mega fuse cover.
    4. Fig 2: Generator Battery Jumper Cable
    GM1699546Courtesy of GENERAL MOTORS CORP.
  4. Remove the generator battery jumper cable to mega fuse nut (3).
  5. Remove the generator battery jumper cable terminal (4) from the mega fuse stud.
  6. Remove the generator battery jumper cable clip (2) from the air conditioning (A/C) evaporator tube.
  7. Remove the generator battery jumper cable clip (1) from the stud.
    8. Fig 3: Battery Jumper Cable Terminal, Nut And Bolt
    GM1702914Courtesy of GENERAL MOTORS CORP.
  8. Reposition the generator battery jumper cable boot (3).
  9. Remove the generator battery jumper cable nut (2) from the generator.
  10. Remove the generator battery jumper cable terminal (1) from the generator stud.
    11. Fig 4: Generator Battery Jumper Cable
    GM1702992Courtesy of GENERAL MOTORS CORP.
  11. Remove the generator battery jumper cable from the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.