SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1844 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - P-R)COMPONENT CONNECTOR END VIEWS - P THROUGH RREARVIEW CAMERA (SPO REARVIEW CAMERA)
2006 Chevrolet Suburban K2500, 6.0 U

Rearview Camera (SPO Rearview Camera)

2006 Chevrolet Suburban K2500, 6.0 USECTION Rearview Camera (SPO Rearview Camera)
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rearview Camera (SPO Rearview Camera)
GM2133378Courtesy of GENERAL MOTORS CORP.
Rearview Camera (SPO Rearview Camera)

Pin Wire Circuit Function
1 0.35 GY/D-BU 7641 Camera Video Signal (+)
2 0.5 WH 6799 Drain Wire
3 0.5 L-GN 38 Backup Lamp Relay Control
4 0.35 GY/OG 7642 Camera Video Signal (-)
5 0.5 BK 1851 Ground
6 0.5 PK 1639 Ignition Voltage
Connector Part Information 
  • Harness: Rearview Camera Chassis
  • OEM: 1924211-1
  • Service: Service by Harness - See Part Catalog
  • Description: 6-Way F 0.64 Series Sealed (NA)
Terminal Part Information 
  • Terminal/Tray: SAIT-A03T-M064/14
  • Core/Insulation Crimp: P/P
  • Release Tool/Test Probe: J-38125-215A/J-35616-64B (L-BU)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.