Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1691 (FIXED AND MOVEABLE WINDOWS SYSTEM)DESCRIPTION AND OPERATIONPOWER WINDOWS DESCRIPTION AND OPERATIONPOWER WINDOW SYSTEM COMPONENTS
2006 Chevrolet Suburban K2500, 6.0 U
Power Window System Components
2006 Chevrolet Suburban K2500, 6.0 USECTION Power Window System Components
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
The power window system consists of the following components:
- Driver Door Switch (DDS) (RPO A31/AN3/DL3)
- Driver window switch (RPO A31 W/O AN3, DL3)
- Passenger Door Switch (PDS) (RPO A31/AN3/DL3)
- Passenger window switch (RPO A31 W/O AN3, DL3)
- Body Control Module (BCM) (RPO A31/AN3/DL3)
- Rear door power window switches
- Power window motors in each of the doors (circuit breaker protected)
- LT DRS Circuit Breaker
- RT DOORS Circuit Breaker
- Sliding Rear Window Switch
- PWR REAR WNDW Circuit Breaker
- Sliding Rear Window Relays
- Sliding Rear Window Motor
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.