Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 159 (SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM)
2006 Chevrolet Suburban K2500, 6.0 U
Section 159 (Supplemental Inflatable Restraint System)
2006 Chevrolet Suburban K2500, 6.0 USECTION Section 159 (Supplemental Inflatable Restraint System)
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Description & Operation
- Component Locations
- System Operation Check
- Air Bag Safety Precautions
- Adjustments
- Disabling & Activating Air Bag System
- Disposal Procedures
- Post-Collision Inspection
- Removal & Installation
- Diagnostics
- Diagnostic Tests
- Notes
- Connector Identification
- Air Bag Warning Light Circuit Malfunction
- DTC B0016,B0017,B0018: Passenger-Side Air Bag Deployment Loop Resistance Low/Resistance High/Short To Ground Or Voltage
- DTC B0022, B0024, B0026: Driver Deployment Loop Resistance Low/Short To Ground Or Voltage/Resistance High
- DTC B0051: Deployment Commanded
- DTC B0053: Deployment Commanded With Loop Malfunction
- DTC B0090: Active Switch Voltage Out Of Range
- DTC B0091: Active Switch: Wrong State
- DTC B1000: Internal SDM Failure
- DTC B1001: Option Configuration Error
- Wire Repair
- Torque Specifications
- Wiring Diagrams
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.