SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1574 (POWER STEERING SYSTEM)REPAIR INSTRUCTIONSPOWER STEERING PUMP REPLACEMENT (LE5)INSTALLATION PROCEDURE
2006 Chevrolet Suburban K2500, 6.0 U

Installation Procedure

2006 Chevrolet Suburban K2500, 6.0 USECTION Installation Procedure
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the power steering pump pulley using installer J 25033-C  .
    2. Fig 1: Power Steering Pump & Bolts
    GM2054366Courtesy of GENERAL MOTORS CORP.
  2. Position the power steering pump (1) to the vehicle.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the power steering pump bolts (2) and tighten to 22 N.m (16 lb ft).
    4. Fig 2: Power Steering Reservoir Outlet Hose & Power Steering Gear Inlet Hose Fitting
    GM2054365Courtesy of GENERAL MOTORS CORP.
  4. Connect the power steering gear inlet hose fitting (1) to the power steering pump. Tighten the fitting to 25 N.m (18 lb ft).
  5. Compress the power steering reservoir outlet hose clamp and connect the power steering reservoir outlet hose (2) to the power steering pump.
  6. Clean any excess fluid from the vehicle and remove the drain pans.
  7. Fill and bleed the power steering system. Refer to Power Steering System Bleeding .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.