Installation Procedure

2006 Chevrolet Suburban K2500, 6.0 USECTION Installation Procedure
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Front Door Window
    GM941821Courtesy of GENERAL MOTORS CORP.
  1. Install the window (2) by sliding the window into the door through the outside door belt opening.
  2. Install the window into the primary glass channels and rest the window on the regulator guide plate.
  3. CAUTION: Refer to Fastener Caution .
  4. Install the window guide bolts (1) to the regulator. Tighten the bolts to 10 N.m (89 lb in).
  5. Install the front door water deflector.
  6. Install the front inner door trim panel. Refer to Front Side Door Trim Panel Replacement .
  7. Inspect the door window for proper operation before installing the door trim panel.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.