Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1560 (BATTERY, CHARGING SYSTEM AND STARTING SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDTC P0615TYPICAL SCAN TOOL DATA
2006 Chevrolet Suburban K2500, 6.0 U
Typical Scan Tool Data
2006 Chevrolet Suburban K2500, 6.0 USECTION Typical Scan Tool Data
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
Starter Relay Ckt Short Gnd Test Status - ECM
| Circuit | Short to Ground | Open | Short to Voltage |
|---|---|---|---|
| Operating Conditions:
Cranking Parameter Normal Value: OK* |
|||
| STRTR Relay Control | Fault | OK | OK |
| Ground | - | OK | - |
| *The parameter displays Not Run when not cranking. | |||
Starter Relay Ckt Open Test Status - ECM
| Circuit | Short to Ground | Open | Short to Voltage |
|---|---|---|---|
| Operating Conditions:
Ignition ON Parameter Normal Value: OK* |
|||
| STRTR Relay Control | OK | Fault | Fault |
| Ground | - | Fault | - |
| *The parameter displays Not Run when cranking. | |||
Starter Relay Ckt Short Volts Test Status - ECM
| Circuit | Short to Ground | Open | Short to Voltage |
|---|---|---|---|
| Operating Conditions:
Ignition ON Parameter Normal Value: OK* |
|||
| STRTR Relay Control | OK | Fault | Fault |
| Ground | - | Fault | - |
| *The parameter displays Not Run when cranking. | |||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.