SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1515 (HYBRID COOLING SYSTEM)REPAIR INSTRUCTIONSCOOLANT TEMPERATURE SENSOR REPLACEMENT (GENERATOR CONTROL MODULE)
2006 Chevrolet Suburban K2500, 6.0 U

Coolant Temperature Sensor Replacement (Generator Control Module)

2006 Chevrolet Suburban K2500, 6.0 USECTION Coolant Temperature Sensor Replacement (Generator Control Module)
WARNING: This page is about a different car, the 2009 GMC Sierra and 2009 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Coolant Temperature Sensor
GM1969725Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedures

  1. Partially drain the generator control module coolant radiator just below the level of the coolant temperature sensor. Refer to Generator Control Module Cooling System Draining and Filling .
  2. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement
  3. Disconnect the engine wiring harness electrical connector from the coolant temperature sensor.
1 Coolant Temperature Sensor
CAUTION: Refer to Fastener Caution .

Tip:  Coolant temperature sensor is located in the generator control module coolant radiator.

Tighten:  20 N.m (15 lb ft)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.