Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1457 (CONFIGURABLE CUSTOMER CONTROL SYSTEM)REPAIR INSTRUCTIONSSTEERING WHEEL CONTROL SWITCH ASSEMBLY REPLACEMENT

2006 Chevrolet Suburban K2500, 6.0 U

Steering Wheel Control Switch Assembly Replacement

2006 Chevrolet Suburban K2500, 6.0 USECTION Steering Wheel Control Switch Assembly Replacement

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Steering Wheel Control Switch Assembly Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
WARNING: Refer to SIR Warning . Preliminary Procedure Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling . Remove the horn switch. Refer to Steering Wheel Horn Switch Replacement .
1	Steering Wheel Trim Cover (Qty: 2) Procedure: Remove the 4 horn contact screws.
2	Steering Wheel Control Switch Assembly Screw (Qty: 4) CAUTION: Refer to Fastener Caution . Tip: Quantity may vary with vehicle options. Tighten: 1 N.m (9 lb in)
3	Steering Wheel Control Switch Assembly (Qty: 2) Tip: Quantity may vary with vehicle options. Ensure the steering wheel control switch(es) are properly seated to the steering wheel shroud during installation.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.