SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1434 (BATTERY, CHARGING SYSTEM AND STARTING SYSTEM)REPAIR INSTRUCTIONSENGINE GROUND STRAP REPLACEMENT (WITH LMM)INSTALLATION PROCEDURE
2006 Chevrolet Suburban K2500, 6.0 U

Installation Procedure

2006 Chevrolet Suburban K2500, 6.0 USECTION Installation Procedure
WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Ground Strap & Nut
    GM1873891Courtesy of GENERAL MOTORS CORP.
  1. Install the ground strap (2) to the vehicle and the stud on the plenum front panel.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the ground strap nut (1) to the stud on the plenum front pane and tighten to 9 N.m (80 lb in).
    3. Fig 2: View Of Engine Ground Strap & Bolt
    GM1873892Courtesy of GENERAL MOTORS CORP.
  3. Position the ground strap (1) to the cylinder head.
  4. Install the ground strap bolt (2) to the cylinder head and tighten to 16 N.m (12 lb ft).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.