Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1328 (WIRING SYSTEMS AND POWER MANAGEMENT - INTRODUCTION)REPAIR INSTRUCTIONSIGNITION LOCK CYLINDER CASE REPLACEMENTINSTALLATION PROCEDURE

2006 Chevrolet Suburban K2500, 6.0 U

Installation Procedure

2006 Chevrolet Suburban K2500, 6.0 USECTION Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Ignition Lock Cylinder & Screws

Courtesy of GENERAL MOTORS CORP.

Install the ignition lock cylinder case (1) to the vehicle.

NOTE: Refer to Fastener Notice .

Install the 3 ignition lock cylinder case screws (2).
Tighten: Tighten the screws to 7 N.m (62 lb in).
Install the park lock cable into the lock cylinder housing.
Connect the passlock and key buzzer to the ignition lock cylinder case.
Install the ignition/start switch. Refer to Ignition and Start Switch Replacement .
Install the inflatable restraint steering wheel module coil. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.