Ignition Lock Key Transmitter Antenna Replacement - Floor Console (Passive)

2006 Chevrolet Suburban K2500, 6.0 USECTION Ignition Lock Key Transmitter Antenna Replacement - Floor Console (Passive)
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Ignition Lock Key Transmitter Antenna Replacement - Floor Console (Passive)
GM1970034Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure:Β 
Remove the cup holder. Refer to Front Floor Console Cup Holder Replacement .
1 Ignition Lock Key Transmitter Antenna

Procedure

  1. Disconnect the electrical connectors.
  2. Unsnap the ignition lock key transmitter antenna from the floor console.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.