SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1257 (COMPONENT LOCATIONS & COMPONENT CONNECTOR END VIEWS)ELECTRICAL CENTER IDENTIFICATION VIEWSFUSE BLOCK - REAR X3
2006 Chevrolet Suburban K2500, 6.0 U

Fuse Block - Rear X3

2006 Chevrolet Suburban K2500, 6.0 USECTION Fuse Block - Rear X3
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Fuse Block - Rear X3 Connector End View
GM823290Courtesy of GENERAL MOTORS CORP.
Fuse Block - Rear X3

Pin Wire Circuit Function
1 - - Not Used
2 1 RD/WH 4740 Battery Positive Voltage
3-5 - - Not Used
6 0.35 YE 1977 Rear Fog Lamp Relay Control (T79)
7-8 - - Not Used
9 0.5 BK/WH 56 Rear Compartment Lid Release Switch
10 - - Not Used
11 0.35 BK 1050 Ground
12 - - Not Used
13 0.35 L-BU 20 Stop Lamp Supply Voltage/Stop Lamp Switch Signal (T90)
14 - - Not Used
Connector Part Information 
  • OEM: 7283-6447-40
  • Service: See Catalog
  • Description: 14-Way F Hybrid Series (L-GY)
Terminal Part Information 
  • Pins: 1, 3-5, 7-8, 10, 12, 14
  • Terminal/Tray: See Terminal Repair Kit
  • Core/Insulation Crimp: See Terminal Repair Kit
  • Release Tool/Test Probe: See Terminal Repair Kit
  • Pins: 2
  • Terminal/Tray: 7116-4101-08/9
  • Core/Insulation Crimp: E/A
  • Release Tool/Test Probe: 12094430/J-35616-2A (GY)
  • Pins: 6, 9, 11, 13
  • Terminal/Tray: 7116-4100-08/9
  • Core/Insulation Crimp: E/C
  • Release Tool/Test Probe: 12094430/J-35616-2A (GY)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.