Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Electronic Brake Control Module (EBCM)
2006 Chevrolet Suburban K2500, 6.0 USECTION Electronic Brake Control Module (EBCM)
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
Electronic Brake Control Module (EBCM)
| Pin | Wire | Circuit | Function |
|---|---|---|---|
| 1 | 5 BK | 1150 | Ground |
| 2 | 0.5 WH | 883 | Right Rear Wheel Speed Sensor Low Reference |
| 3 | 0.5 BN | 882 | Right Rear Wheel Speed Sensor Signal |
| 4 | 0.5 BK | 884 | Left Rear Wheel Speed Sensor Signal |
| 5 | 0.5 RD | 885 | Left Rear Wheel Speed Sensor Low Reference |
| 6 | 0.5 TN | 833 | Right Front Wheel Speed Sensor Low Reference |
| 7-11 | - | - | Not Used |
| 12 | 0.35 L-BU | 5986 | Serial Data Communication Enable |
| 13 | 5 RD | 242 | Battery Positive Voltage |
| 14 | 0.5 BN | 1295 | Variable Effort Steering Actuator Control |
| 15-16 | - | - | Not Used |
| 17 | 0.5 D-GN | 872 | Right Front Wheel Speed Sensor Signal |
| 18 | 0.35 GY | 1056 | Steering Wheel Position Sensor 5V Reference Voltage |
| 19 | 0.35 GY/BK | 1337 | 12-Volt Reference |
| 20 | - | - | Not Used |
| 21 | 0.35 L-GN/BK | 6432 | CAN Bus Low Serial Data |
| 22 | - | - | Not Used |
| 23 | 0.5 TN | 2501 | High Speed GMLAN Serial Data Bus- |
| 24 | 0.5 TN | 2501 | High Speed GMLAN Serial Data Bus- |
| 25 | 2 BK | 1150 | Ground |
| 26 | 0.5 WH | 1294 | Variable Effort Steering Actuator Supply Voltage |
| 27 | - | - | Not Used |
| 28 | 0.5 L-BU | 830 | Left Front Wheel Speed Sensor Signal |
| 29 | 0.5 YE | 873 | Left Front Wheel Speed Sensor Low Reference |
| 30-31 | - | - | Not Used |
| 32 | 0.35 D-GN/WH | 817 | Vehicle Speed Signal |
| 33 | 0.35 TN/WH | 6433 | CAN Bus High Serial Data |
| 34-35 | - | - | Not Used |
| 36 | 0.5 TN/WH | 2500 | High Speed GMLAN Serial Data Bus+ |
| 37 | 0.5 TN/WH | 2500 | High Speed GMLAN Serial Data Bus+ |
| 38 | 2 RD | 42 | Battery Positive Voltage |
Connector Part Information
|
Terminal Part Information
|
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.