Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1220 (LIGHTING SYSTEMS)DIAGNOSTIC INFORMATION AND PROCEDURESCOURTESY LAMPS MALFUNCTIONCIRCUIT/SYSTEM VERIFICATION
2006 Chevrolet Suburban K2500, 6.0 U
Circuit/System Verification
2006 Chevrolet Suburban K2500, 6.0 USECTION Circuit/System Verification
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition ON, observe the scan tool ctsy. lamp actv. reason parameter while pressing and releasing the dome lamp switch. The reading should toggle between OFF and MANUAL.
- If the reading does not change between the commanded states, refer to Dome Lamp Switch Malfunction .
- Observe the scan tool driver door open switch parameter while opening and closing the driver door. The reading should toggle between ACTIVE and INACTIVE.
- If the reading does not change between the commanded states, refer to Door Courtesy Lamp Malfunction - Front .
- Observe the scan tool passenger door open switch parameter while opening and closing the passenger door. The reading should toggle between ACTIVE and INACTIVE.
- If the reading does not change between the commanded states, refer to Door Courtesy Lamp Malfunction - Front Door Open Switch Malfunction - Front.
- Open each rear door one at a time and observe the courtesy lamps. The courtesy lamps should illuminated when each rear door is opened.
- If the courtesy lamps do not illuminate as each rear door is opened, refer to Door Courtesy Lamp Malfunction - Rear .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.