Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1151 (POWER STEERING SYSTEM)REPAIR INSTRUCTIONSSTEERING GEAR REPLACEMENT (NON-RACK AND PINION)REMOVAL PROCEDURE

2006 Chevrolet Suburban K2500, 6.0 U

Removal Procedure

2006 Chevrolet Suburban K2500, 6.0 USECTION Removal Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Remove as much power steering fluid from the power steering fluid reservoir as possible.
Place drain pans under the vehicle as needed.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .

NOTE: Refer to POWER STEERING HOSE DISCONNECTED NOTICE .

Remove the engine shield, if equipped. Refer to Engine Shield Replacement .
If equipped with a diesel engine, remove the left wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Left Side (Chevrolet) or Front Wheelhouse Liner Replacement - Left Side (GMC) .
Disconnect the steering hoses from the steering gear.
Disconnect the steering shaft coupling from the steering gear. Refer to Steering Shaft Coupling Replacement .

Fig 1: View Of Pitman Arm Nut

Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.