Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1151 (POWER STEERING SYSTEM)REPAIR INSTRUCTIONSPOWER STEERING PUMP FLOW CONTROL VALVE REPLACEMENT - OFF VEHICLE
2006 Chevrolet Suburban K2500, 6.0 U
Power Steering Pump Flow Control Valve Replacement - Off Vehicle
2006 Chevrolet Suburban K2500, 6.0 USECTION Power Steering Pump Flow Control Valve Replacement - Off Vehicle
WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| Preliminary Procedure: Remove the power steering pump assembly. Refer to Power Steering Pump Replacement (4.3L) or Power Steering Pump Replacement (4.8L, 5.3L, 6.0L, and 6.2L) or Power Steering Pump Replacement (6.6L) . |
|
| 1 | Power Steering Fluid Reservoir |
| 2 | Power Steering Pump Fitting
NOTE:
Refer to Fastener Notice
.
Tighten: 75 N.m (55 lb ft) |
| 3 | Power Steering Pump Fitting Seal Procedure: Apply power steering fluid to the power steering pump fitting seal before installing. |
| 4 | Power Steering Pump Flow Control Valve |
| 5 | Power Steering Pump Flow Control Valve Spring |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.