SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 114 (ENGINE CONTROLS - REMOVAL & INSTALLATION, OVERHAUL)FUEL SYSTEMSFUEL SENDER (WITHOUT FEEDBACK FUEL SYSTEM)INSTALLATION
2006 Chevrolet Suburban K2500, 6.0 U

Fuel Sender (Without Feedback Fuel System): Installation

2006 Chevrolet Suburban K2500, 6.0 USECTION Installation
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the fuel sender gasket for damage and replace if necessary. Insert the float arm through the fuel tank opening. Do not bend or twist the float arm. The fuel sender may need to be rotated in order to facilitate the installation.
  2. Align the fuel sender gasket tab with the fuel sender cover mark. See Fig 1. Align the fuel sender cover mark with the fuel tank mark. Hand tighten the fuel sender attaching bolts until finger tight.
  3. Tighten the fuel sender assembly attaching bolts to specification in the proper sequence. See Fig 1. See TORQUE SPECIFICATIONS .
  4. Reconnect the fuel pipes to the fuel sender assembly. Connect the fuel sender electrical connector. Install the fuel tank strap. Install the fuel tank strap bolts to specification. Install the fuel tank shield. Install the fuel tank shield mount bolt/nut and tighten to specification.
  5. Install the rear wheel and tire assembly. Tighten wheel lug nuts to specification. See TORQUE SPECIFICATIONS . Lower the vehicle. Refill the fuel system. Install the fuel filler cap. Connect the negative battery cable. Perform the following procedure in order to inspect for leaks. Turn the ignition on for 2 seconds. Turn the ignition off 10 seconds. Turn the ignition on. Inspect for fuel leaks.
  6. Check if keyless entry transmitters function properly. If battery was disconnected, transmitter may not communicate or may loose synchronization with the receiver. If transmitters do not function properly, reprogram transmitters. See KEYLESS ENTRY TRANSMITTER SYNCHRONIZATION  under PROGRAMMING.
Fig 1: Aligning Fuel Sender Gasket & Identifying Fuel Sender Assembly Bolt Tightening Sequence
G00114724Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.